At just 18" wide, this greenhouse staging is ideal for small greenhouses (e.g. 5' or 6' wide). The sections are 22" long and you can bolt as many together as you wish. (e.g an 8' run would be four sections bolted together and would therefore be 7'4" long- ideal to fit into an 8' gap)

Made from sturdy aluminium frame with 1" deep aluminium trays. All the trays have a double folded safety edge for safety.

Height: 32" / 813mm

This new staging consists of an extremely sturdy aluminium frame (each piece of staging has 16 corner braces for superb rigidity). The tops are made from tanalised timber slats (pressure treated so that you never have to re-treat).

Please note that we say 2' for the sake of clarity, in fact they are a bit smaller so that they fit into the greenhouses well. All Caverswall staging is delivered completely flat packed for self assembly.

The height of this Staging is 930mm/3'1" high

W 470mm x L 575mm x H 930mm

This new staging consists of an extremely sturdy aluminium frame (each piece of staging has 16 corner braces for superb rigidity). The tops are made from tanalised timber slats (pressure treated so that you never have to re-treat).

Please note that we say 2' for the sake of clarity, in fact they are a bit smaller so that they fit into the greenhouses well. The respective exact measurements are 457mm and 610mm.

All Caverswall staging is delivered completely flat packed for self assembly.

The height of this Staging is 770mm/2'7" high

W 47cm L 57.5cm H 77cm

You can improve the performance of the ventillation in your greenhouse by adding autovents. These handy devices open vents automatically and don't require batteries, working from heat alone.

Also, they tend to allow the vent to open more than a conventional manual opener, equaling better ventilation.

Roof Vents in your greenhouse allow you to provide ventilation and air circulation in your greenhouse, especially important during the summer months when your greenhouse can get very warm. So it's important when you purchase your greenhouse that you have sufficient roof vents for the size of greenhouse, you can have too few roof vents. It's also much more difficult to fit roof vents after you've built your greenhouse than it would be to fit them when you're building your greenhouse.

The frame is manufactured from aluminium and it comes complete with 5 toughened glass slats.

You can improve the ventilation in your greenhouse by adding extra louvres. They allow fresh air to enter your greenhouse. This Louvre is designed to replace a piece of glass 610mm x 457mm (2ft x 18"). Please note if you are ordering a new greenhouse at the same time as this louvre, we will automatically adjust the glass in the greenhouse.