This waterbutt is finished in an attractive black finish and is made from durable plastic.

It has a capacity of 100 litres and comes complete with a tap and a lid which has secure fit.

950mm x 380mm x 380mm

*Please note - stand sold separately

New model with external, more accurate thermostat probe. Now also comes with temperatures listed on dial*

This newly developed fan heater is ideal for use in your greenhouse or other outbuilding. The strong metal casing is powdercoated in an attractive Anthracite colour, and will outperform the plastic cases of rival heaters. Inside is a stainless steel heating element and good quality fan which circulates c.186m3 per hour ensuring that the temperature in your greenhouse is kept relatively even all over the greenhouse by the good movement of air.

In order to be safe for greenhouse use, new regulations state that greenhouse heaters should be IPX4 rated or above, meaning that if they encounter some wet conditions or splashing they should be safe. This model is IPX4 rated.

You can use this heater as a fan only (in summer) or you can set the switch to 1kW heat or 2kW heat depending on how big your greenhouse is. There is also a thermostat included which can be adjusted and the heater will click off when the desired setting is reached. We recommend that you use the heater in conjunction with a max min thermometer in your greenhouse, to help you fine- tune your set-up.

We are often asked what size greenhouse this heater will heat and there is no definite answer for that, as it depends on how cold it is outside and how warm you want it in the greenhouse. As a general guide, a 2kW will heat up to an 8x12 greenhouse, possibly a little bigger if you only want it frost free. If you are pushing the borderline with this, then take extra measures during a very cold snap (e.g -10 at night) such as adding more heat or turning the thermostat up to allow a bigger buffer during the coldest part of the night.

Measurements: 230x198x320

2kW

Fan only: 25W

IPX4 rated

1.3m Cable 

 *We recommend you have a Maximum - Minimum thermometer to monitor temperatures more accurately

This mechanical device is designed to automatically open and close a louvre vent, in response to temperature.

A wax-like substance, contained in the cylinder, expands with heat, operating a piston which opens the louvre via a linkage arm. As the temperature falls, the process reverses, and a spring closes the louvre. There is also an adjustment knob, which enables the opening temperature to be altered to between 15 and 25 degrees centigrade.

Some simple drilling is required to fit the opener to the side of the louvre vent.

Hand made by us in our Staffordshire workshop, trade enquiries welcome from all around the world

This product does NOT fit the Hercules OCTAGONAL range of buildings

- Wheelchair friendly

- Extend to any length

- Wheelchair friendly

Suitable for the 100l Slim Waterbutt. This stand raises the water butt high enough to be able to place a watering can below the tap. This item is essential if you don't intend to make your own stand for your waterbutt.

Diameter 17.5"/45cm (bottom) 16"/41cm (top)

Height 12"/30cm